Dell Force10 Z9000 - Host; Lease

Version 8.2.1.0 Introduced on the C-Series and S-Series.
host
For manual (rather than automatic) configurations, assign a host to a single-address pool.
C-Series, S-Series, Z-Series, S4810
Syntax
host address
Parameters
address/mask Enter the host IP address and subnet mask.
Defaults none
Command Modes DHCP <POOL>
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
lease
Specify a lease time for the addresses in a pool.
C-Series, S-Series, Z-Series, S4810
Syntax
lease {days [hours] [minutes] | infinite}
Parameters
days Enter the number of days of the lease. The range is 0 to 31.
hours Enter the number of hours of the lease. The range is 0 to 23.
minutes Enter the number of minutes of the lease. The range is 0 to 59.
infinite Specify that the lease never expires.
Defaults 24 hours
Command Modes DHCP <POOL>
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
595