Dell Force10 Z9000 - Show Ip Bgp Cluster-List

701 80 i
*> 63.114.8.33 0 18508 701 80
i
*> 3.3.0.0/16 0.0.0.0 22 32768 ?
63.114.8.35 0 18508 ?
*> 4.0.0.0/8 63.114.8.33 0 18508 701 1 i
*> 4.2.49.12/30 63.114.8.33 0 18508 209 i
* 4.17.250.0/24 63.114.8.33 0 18508 209
1239 13716 i
*> 63.114.8.33 0 18508 701
1239 13716 i
* 4.21.132.0/23 63.114.8.33 0 18508 209
6461 16422 i
*> 63.114.8.33 0 18508 701
6461 16422 i
*> 4.24.118.16/30 63.114.8.33 0 18508 209 i
*> 4.24.145.0/30 63.114.8.33 0 18508 209 i
*> 4.24.187.12/30 63.114.8.33 0 18508 209 i
*> 4.24.202.0/30 63.114.8.33 0 18508 209 i
*> 4.25.88.0/30 63.114.8.33 0 18508 209
3561 3908 i
*> 5.0.0.0/9 63.114.8.33 0 0 18508 ?
*> 5.0.0.0/10 63.114.8.33 0 0 18508 ?
*> 5.0.0.0/11 63.114.8.33 0 0 18508 ?
--More--
Related
Commands
show ip bgp community – views the BGP communities.
neighbor maximum-prefix – controls the number of network prefixes received.
show ip bgp cluster-list
View BGP neighbors in a specific cluster.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip bgp [ipv4 unicast] cluster-list [cluster-id]
Parameters
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
cluster-id (OPTIONAL) Enter the cluster id in dotted decimal format.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
The following describes the show ip bgp cluster-list command shown in the
Example below.
389