Dell Force10 Z9000 - Page 388

Parameters
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
network (OPTIONAL) Enter the network address (in dotted decimal format) of
the BGP network to view information only on that network.
network-mask (OPTIONAL) Enter the network mask (in slash prefix format) of the
BGP network address.
longer-prefixes (OPTIONAL) Enter the keywords longer-prefixes to view all
routes with a common prefix.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Added the add-path option to the S4810. Output on the S4810
shows the ADDPATH parameters.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
When you enable the bgp non-deterministic-med command, the show ip bgp
command output for a BGP route does not list the INACTIVE reason.
The following describes the show ip bgp command shown in the Example below.
Field Description
Network Displays the destination network prefix of each BGP route.
Next Hop Displays the next hop address of the BGP router. If 0.0.0.0 is listed in
this column, then local routes exist in the routing table.
Metric Displays the BGP route’s metric, if assigned.
LocPrf Displays the BGP LOCAL_PREF attribute for the route.
Weight Displays the route’s weight.
Path Lists all the ASs the route passed through to reach the destination
network.
Example
FTOS>show ip bgp
BGP table version is 847562, local router ID is 63.114.8.131
Status codes: s suppressed, d damped, h history, * valid, >
best
Path source: I - internal, a - aggregate, c - confed-external,
r - redistributed, n - network
Origin codes: i - IGP, e - EGP, ? - incomplete
Network Next Hop Metric LocPrf Weight Path
*> 0.0.0.0/0 63.114.8.33 0 18508 i
* 3.0.0.0/8 63.114.8.33 0 18508 209
388