Dell Force10 Z9000 - Show Ip Cam Linecard

Name servers are not set
Host Flags TTL Type Address
-------- ----- ---- ---- -------
ks (perm, OK) - IP 2.2.2.2
4200-1 (perm, OK) - IP 192.68.69.2
1230-3 (perm, OK) - IP 192.68.99.2
ZZr (perm, OK) - IP 192.71.18.2
Z10-3 (perm, OK) - IP 192.71.23.1
FTOS#
Related
Commands
traceroute – views the DNS resolution.
ip host – configures a host.
show ip cam linecard
View CAM entries for a port pipe on a line card.
C-Series, E-Series, S4810
Syntax
show ip cam linecard number port-set pipe-number [ip-address
mask [longer-prefixes] | index index-number | summary | vrf vrf
instance]
Parameters
number Enter the number of the line card. The range is 0 to 13 on a
E1200/1200i, 0 to 6 on a E600600i, and 0 to 5 on a E300.
pipe-number Enter the number of the line card’s port-pipe. The range is 0 to 1.
ip-address mask
[longer-prefix]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries
for that route only. Enter the keyword longer-prefixes to view
routes with a common prefix.
index index-
number
(OPTIONAL) Enter the keyword index followed by the CAM index
number. The range depends on CAM size.
summary (OPTIONAL) Enter the keyword summary to view a table listing route
prefixes and the total number of routes that can be entered into the
CAM.
vrf instance (OPTIONAL) E-Series Only: Enter the keyword vrf followed by the
VRF instance name to show CAM information as it applies to that VRF
instance.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.2 Introduced on the E-Series ExaScale E600i.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
808