Dell Force10 Z9000 - Sflow Extended-Switch Enable

Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
FTOS 7.8.1.0 and later enhances the sflow implementation for real time traffic analysis on the E-
Series to provide extended gateway information in cases where the destination IP addresses
are learned by different routing protocols and for cases where the destination is reachable
over ECMP.
Related
Commands
sflow extended-gateway enable – enables packing information on an extended gateway.
sflow extended-switch enable – enables packing information on a switch.
show sflow – displays the sFlow configuration.
sflow extended-switch enable
Enable packing information on a switch only.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
sflow extended-switch enable
To disable packing information, use the no sflow extended-switch [enable]
command.
Parameters
enable Enter the keyword enable to enable global extended information.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on S-Series Stacking.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
FTOS 7.8.1.0 and later enhances the sflow implementation for real time traffic analysis on the E-
Series to provide extended gateway information in cases where the destination IP addresses
1354