Dell Force10 Z9000 - Show Ip Bgp Filter-List

• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
To view the total number of COMMUNITY attributes found, use the show ip bgp
summary command. The text line above the route table states the number of COMMUNITY
attributes found.
The show ip bgp community command without any parameters lists BGP routes with at
least one BGP community attribute and the output is the same as for the show ip bgp
command output.
show ip bgp filter-list
View the routes that match the filter lists.
C-Series, E-Series, S-Series, S-Series, S4810
Syntax
show ip bgp [ipv4 unicast] filter-list as-path-name
Parameters
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
as-path-name Enter the name of an AS-PATH.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
The following describes the show ip bgp filter-list hello command shown in
the Example below.
Field Description
Path source codes Lists the path sources shown to the right of the last AS number in the
Path column:
• i = internal route entry
397