Dell Force10 Z9000 - Ntp Trusted-Key

Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
ntp trusted-key
Set a key to authenticate the system to which NTP will synchronize.
C-Series, E-Series, S-Series, Z-Series
Syntax
ntp trusted-key number
To delete the key, use the no ntp trusted-key number command.
Parameters
number Enter a number as the trusted key ID. The range is 1 to 4294967295.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
The number parameter in the ntp trusted-key command must be the same number as
the number parameter in the ntp authentication-key command. If you change the
ntp authentication-key command, you must also change the ntp trusted-key
command.
Related
Commands
ntp authentication-key – sets an authentication key for NTP.
ntp authenticate – enables the NTP authentication parameters you set.
1438