Dell Force10 Z9000 - Protocol-Tunnel Rate-Limit; Show Protocol-Tunnel

protocol-tunnel rate-limit
Enable traffic rate limiting per box.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
protocol-tunnel rate-limit rate
To reset the rate limit to the default, use the no protocol-tunnel rate-limit rate
command.
Parameters
rate Enter the rate in frames per second. The range is 75 to 3000. The
default is 75.
Defaults 75 frames per second.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series, E-Series Terascale, and E-Series
ExaScale. Maximum rate limit on E-Series reduced from 4000 to 3000.
Version 7.4.1.0 Introduced
Example
FTOS#
FTOS#conf
FTOS(conf)#protocol-tunnel rate-limit 1000
FTOS(conf)#
Related
Commands
show protocol-tunnel – displays tunneling information for all VLANs.
show running-config – displays the current configuration.
show protocol-tunnel
Display protocol tunnel information for all or a specified VLAN-Stack VLAN.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show protocol-tunnel [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter the keyword vlan followed by the VLAN ID to
display information for the one VLAN. The range is 1 to 4094.
Defaults none
Command Modes EXEC
1347