Dell Force10 Z9000 - Ipg (Gigabit Ethernet Interfaces); Ipg (10 Gigabit Ethernet Interfaces)

interface port-channel – configures a port channel group.
show vlan – displays the current VLAN configuration on the switch.
shutdown – disables/enables the VLAN.
tagged – adds a Layer 2 interface to a VLAN as a tagged interface.
untagged – adds a Layer 2 interface to a VLAN as an untagged interface.
openflow of-instance — creates or modifies an OpenFlow instance.
ipg (Gigabit Ethernet interfaces)
Set the inter-packet gap (IPG) to 8 bytes for traffic on a Gigabit Ethernet interface.
E-Series
Syntax
ipg 8
To return to the default setting, use the no ipg command.
Parameters
8 Enter the keyword 8 to set the IPG to 8 bytes.
Defaults 12 bytes
Command Mode INTERFACE
Command History
Version 8.2.1.0 Support for 4093 VLANs on E-Series ExaScale. Prior releases
supported 2094.
Version 8.1.1.0 Introduced on E-Series ExaScale.
pre-Version
6.1.1.0
Introduced for E-Series
Usage
Information
For 1-Gigabit Ethernet interfaces only.
NOTE: This command is an EtherScale-only command.
ipg (10 Gigabit Ethernet interfaces)
Set the inter-packet gap for traffic on 10–Gigabit Ethernet interface.
E-Series
Syntax
ipg {ieee-802.3ae | shrink}
To return to the default of averaging the IPG, use the no ipg {shrink |
ieee-802.3ae} command.
708