Dell Force10 Z9000 - Stack-Unit Stack-Group; Vlan-Stack Access

stack-unit stack-group
Configure stacking group specified by ID.
S4810
Syntax
[no] stack-unit unit-id stack-group stack-group-id
Parameters
unit-id Enter the stack unit ID.
stack-group-id Enter the stack group ID. The range is 0 to 16.
[no] Use no stack-unit unit-id stack-group stack-id
to remove the current stack group configuration.
Command Modes CONFIGURATION
Command History
Version 8.3.10.2 Introduced on the S4810.
Usage
Information
WARNING: The following message displays to confirm the command: All non-
default configurations on the related member ports ports
(<ports listed here>) will be removed. Do you want to
continue (y/n)? If you enter “y”, all non-default configurations on any member
ports of the current stack group is removed when the unit is rebooted.
vlan-stack access
Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults Not configured.
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
E-Series original
Command
1450