Dell Force10 Z9000 - Neighbor Remove-Private-As; Neighbor Route-Map

neighbor remove-private-as
Remove private AS numbers from the AS-PATH of outgoing updates.
C-Series, E-Series TeraScale, S-Series
Syntax
neighbor {ip-address | peer-group-name} remove-private-as
To return to the default, use the no neighbor {ip-address | peer-group-name}
remove-private-as command.
Parameters
ip-address Enter the IP address of the neighbor to remove the private AS
numbers.
peer-group-name Enter the name of the peer group to remove the private AS numbers.
Defaults Disabled (that is, private AS numbers are not removed).
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
Command History
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series. Added 4-byte support.
Version 7.6.1.0 Introduced IPv6 MGBP on the E-Series.
neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
C-Series, E-Series TeraScale, S-Series
Syntax
neighbor {ip-address | peer-group-name} route-map map-name {in
| out}
To remove the route map, use the no neighbor {ip-address | peer-group-
name} route-map map-name {in | out} command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
map-name
Enter the name of an established route map.
If the Route map is not configured, the default is deny (to drop all
routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
Defaults Not configured.
Command Modes ROUTER BGP Address Family (conf-router_bgp_af)
429