Usage
Information
The LED setting is not saved through power cycles.
send
Send messages to one or all terminal line users.
C-Series, E-Series, S-Series, Z-Series
Syntax
send [*] | [line ] | [aux] | [console] | [vty]
Parameters
* Enter the asterisk character * to send a message to all tty lines.
line
Send a message to a specific line. Range: 0 to 11.
aux Enter the keyword aux to send a message to an auxiliary line.
NOTE: This option is supported on the E-Series only.
console Enter the keyword console to send a message to the primary
terminal line.
vty Enter the keyword vty to send a message to the virtual terminal.
Defaults none
Command Modes EXEC
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.5.1.0 Introduced on the E-Series.
Usage
Information
Messages can contain an unlimited number of lines; however, each line is limited to 255
characters. To move to the next line, use the <CR>. To send the message use CTR-Z;to abort
a message use
CTR-C.
133
To Next Page
Loading...
