mac-address-table station-move refresh-arp
Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs due to a
topology change.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
[no] mac-address-table station-move refresh-arp
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
For details about using this command, refer to the “NIC Teaming” section of the Layer 2
chapter in the
FTOS Configuration Guide
.
mac cam fib-partition
Reapportion the amount of content addressable memory (CAM) available for MAC address learning forwarding
information base (FIB) versus the amount available for MAC ACLs on a line card.
E-Series
Syntax
mac cam fib-partition {25 | 50 | 75 | 100} slot-number
To return to the default setting, use the no mac cam fib-partition command.
Parameters
25 Enter the keyword 25 to set aside 25% of the CAM for MAC address
learning.
50 Enter the keyword 50 to set aside 50% of the CAM for MAC address
learning.
75 Enter the keyword 75 to set aside 75% of the CAM for MAC address
learning.
100 Enter the keyword 100 to set aside 100% of the CAM for MAC
address learning. With this configuration, no MAC ACLs are
processed.
slot-number
Enter the line card slot number. The range is 0 to 13 for the E1200, 0 to
6 for the E600, and 0 to 5 for the E300.
921
To Next Page
Loading...
