Dell Force10 Z9000 - Advertise-Interval; Authentication-Type; Object Missing

Object Missing
This object is not available in the repository.
advertise-interval
Set the time interval between VRRP advertisements.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
advertise-interval seconds
To return to the default settings, use the no advertise-interval command.
Parameters
seconds Enter a number of seconds. The range is 1 to 255. The default is 1
second.
Defaults 1 second
Command Modes INTERFACE-VRRP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
Dell Force10 recommends keeping the default setting for this command. If you do change the
time interval between VRRP advertisements on one router, you must change it on all routers.
authentication-type
Enable authentication of VRRP data exchanges.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
authentication-type simple [encryption-type] password
To delete an authentication type and password, use the no authentication-type
command.
Parameters
simple Enter the keyword simple to specify simple authentication.
encryption-type (OPTIONAL) Enter one of the following numbers:
• 0 (zero) specifies an un-encrypted authentication data will
follow.
• 7 (seven) specifies a hidden authentication data will follow.
• LINE is the un-encrypted (cleartext) authentication data.
1471