Dell Force10 Z9000 - Show Interfaces Status

show interfaces status
Display a summary of interface information or specify a line card slot and interface to display status information on that
specific interface only.
C-Series, E-Series, S-Series, Z-Series
Syntax
show interfaces [interface | linecard slot-number] status
Parameters
interface (OPTIONAL) Enter one of the following keywords and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
linecard slot-
number
(OPTIONAL) Enter the keyword linecard followed by the slot
number. For the C-Series, the range is 0 to 7 for C300 and 0 to 3 for
C150. For the E-Series, the range is 0 to 13 on the E1200, 0 to 6 on the
E600, and 0 to 5 on the E300
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.5.1.0 Introduced on the E-Series.
Example
FTOS#show interfaces status
Port Description Status Speed Duplex Vlan
Gi 0/0 Up 1000 Mbit Auto --
Gi 0/1 Down Auto Auto 1
Gi 0/2 Down Auto Auto 1
Gi 0/3 Down Auto Auto --
Gi 0/4 FTOSPort Up 1000 Mbit Auto 30-130
Gi 0/5 Down Auto Auto --
Gi 0/6 Down Auto Auto --
Gi 0/7 Up 1000 Mbit Auto
1502,1504,1506-1508,1602
Gi 0/8 Down Auto Auto --
737