Dell Force10 Z9000 - Restore Fpga-Image

Version 8.3.1.0 Added the rpm option.
Version 7.5.1.0 Introduced on the C-Series.
Example
FTOS#upgrade sfm 1 autoreset
SFM1: upgrade in progress
!!! !!! !!!
SFM1: upgrade complete
SFM1 is active. Resetting it might temporarily impact traffic.
Proceed with reset [confirm yes/no]: yes
FTOS#
Usage
Information
Reset the card using the power-cycle option after restoring the FPGA command.
Related
Commands
• reset – resets a line card or RPM.
• restore fpga-image – this command copies the backup FPGA image to the primary
FPGA image.
restore fpga-image
Copy the backup C-Series FPGA image to the primary FPGA image.
C-Series
Syntax
restore fpga-image {rpm | linecard} number
Parameters
rpm Enter the keyword rpm to upgrade an RPM FPGA.
linecard Enter the keyword linecard to upgrade a line card FPGA.
number Enter the linecard or RPM slot number. For the C-Series linecard, the
range is 0 to 7 and for RPM, the range is 0 to 1.
Defaults none
Command Modes EXEC Privilege
Command History
Version 7.7.1.0 Renamed the keyword primary-fpga-flash to fpga-image.
Version 7.5.1.0 Introduced on the C-Series.
Example
FTOS#restore fpga-image linecard 4
Current FPGA information in the system:
=======================================
Card FPGA Name Current Version New Version
-----------------------------------------------------------
LC4 48 Port 1G LCM FPGA A: 3.6 restore
************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade
93