Dell Force10 Z9000 - Source (Port Monitoring)

Related
Commands
monitor session – Creates a session for monitoring.
show monitor session – Displays a monitor session.
source (port monitoring)
Configure a port monitor source.
C-Series, E-Series, S-Series, Z-Series
Syntax
source interface destination interface direction {rx | tx |
both}
To disable a monitor source, use the no source interface destination
interface direction {rx | tx | both} command.
Parameters
interface Enter the one of the following keywords and slot/port information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
destination Enter the keyword destination to indicate the interface
destination.
direction {rx | tx |
both}
Enter the keyword direction followed by one of the packet
directional indicators.
• rx: to monitor receiving packets only.
• tx: to monitor transmitting packets only.
• both: to monitor both transmitting and receiving packets.
Defaults none
Command Modes MONITOR SESSION (conf-mon- sess-session-ID )
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
1154