Dell Force10 Z9000 - Redistribute

redistribute
Redistribute routes into BGP.
E-Series
Syntax
redistribute {connected | static} [route-map map-name]
To disable redistribution, use the no redistribution [connected | static]
[route-map map-name] command.
Parameters
connected Enter the keyword connected to redistribute routes from physically
connected interfaces.
static Enter the keyword static to redistribute manually configured
routes. These routes are treated as incomplete routes.
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by the name
of an established route map. Only the following ROUTE-MAP mode
commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If the route map is not configured, the default is deny (to drop all
routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 7.4.1.0 Introduced
Usage
Information
If you do not configure the default-metric command in addition to the redistribute
command, or there is no route map to set the metric, the metric for redistributed static and
connected is “0”.
To redistribute the default route (0::0/0), configure the neighbor default-originate
command.
Related
Commands
neighbor default-originate – injects the default route.
497