Dell Force10 Z9000 - 12 Debugging and Diagnostics; Diagnostics and Monitoring Commands; Logging Coredump

12
Debugging and Diagnostics
The debugging and diagnostics commands are supported on the Dell Force10 C-Series, E-Series, S-Series, and Z-Series
platforms.
This chapter contains the following sections:
• Diagnostics and Monitoring Commands
• Offline Diagnostic Commands
• Buffer Tuning Commands
• Hardware Commands
Diagnostics and Monitoring Commands
The following section describes the diagnostics and monitoring commands.
For similar commands, refer to the Control and Monitoring chapter.
logging coredump
Enable coredump.
C-Series, E-Series, S-Series, Z-Series
Syntax
logging coredump {cp | linecard {number | all} | rps}
Parameters
cp Enable coredump for the CP.
linecard Enable coredump for a linecard.
rps Enable coredump for RP 1 and 2.
Defaults The kernal coredump is enabled by default for RP 1 and 2 on the E-Series. The kernel coredump
for CP and application coredump are disabled on all systems by default.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 7.7.1.0 Restructured the command to accommodate core dumps for CP.
Introduced on the C-Series and S-Series.
Version 6.5.1.0 Application coredump naming convention enhanced to include
application.
Version 6.1.1.0 Introduced
567