Dell Force10 Z9000 - Show Config

Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
STP is not enabled when you enter SPANNING TREE mode. To enable STP globally on the
switch, use the no disable command from SPANNING TREE mode.
Example
FTOS(conf)#protocol spanning-tree 0
FTOS(config-stp)#
Related
Commands
disable – disables spanning tree group 0. To enable spanning tree group 0, use the no
disable
command.
show config
Display the current configuration for the mode. Only non-default values are displayed.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show config
Command Modes SPANNING TREE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Example
FTOS(config-stp)#show config
protocol spanning-tree 0
no disable
FTOS(config-stp)#
1417