Dell Force10 Z9000 - Hardware Commands; Clear Hardware Stack-Unit

Hardware Commands
These commands display information from a hardware sub-component or ASIC.
clear hardware stack-unit
Clear statistics from selected hardware components.
S-Series, Z-Series
Syntax
clear hardware stack-unit 0–7 {counters | unit 0–1 counters |
cpu data-plane statistics | cpu party-bus statistics | stack-
port 0–52}
Parameters
stack-unit 0-7 Enter the keywords stack-unit followed by 0 to 7 to select a
particular stack member and then enter one of the following
command options to clear a specific collection of data.
counters Enter the keyword counters to clear the counters on the selected
stack member.
unit 0–1 counters Enter the keyword unit along with a port-pipe number, from 0 to 1,
followed by the keyword counters to clear the counters on the
selected port-pipe.
NOTE: S25 models (S25N, S25P, S25V, etc.) have only port-pipe 0.
cpu data-plane
statistics
Enter the keywords cpu data-plane statistics to clear the
data plane statistics.
cpu party-bus
statistics
Enter the keywords cpu party-bus statistics to clear the
management statistics.
stack-port 0–52 Enter the keywords stack-port followed by the port number of the
stacking port to clear the statistics of the particular stacking port. The
range is 0 to 52.
Defaults none
Command Modes EXEC Privilege
Command History
Version 8.3.11.0 Introduced on the Z9000.
Version 7.8.1.0 Introduced on the S-Series.
Related
Commands
show hardware stack-unit – displays the data plane or management plane input and output
statistics of the designated component of the designated stack member.
579