Dell Force10 Z9000 - Show Ip Ospf Database Router

adv-router ip-
address
(OPTIONAL) Enter the keywords adv-router followed by the IP
address of an Advertising Router to display only the LSA information
about that router.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Related
Commands
show ip ospf database – displays OSPF database information.
show ip ospf database router
Display the router (type 1) LSA information.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip ospf process-id database router [link-state-id] [adv-
router ip-address]
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
link-state-id (OPTIONAL) Specify LSA ID in dotted decimal format. The LSA ID
value depends on the LSA type, and it can be one of the following:
• the network’s IP address for Type 3 LSAs or Type 5 LSAs
• the router’s OSPF router ID for Type 1 LSAs or Type 4 LSAs
• the default destination (0.0.0.0) for Type 5 LSAs
adv-router ip-
address
(OPTIONAL) Enter the keywords adv-router followed by the IP
address of an Advertising Router to display only the LSA information
about that router.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
1086