Dell Force10 Z9000 - Show Sflow Linecard

Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 6.2.1.1 Introduced on the E-Series.
Usage
Information
The dropEvent counter (sFlow samples dropped due to sub-sampling) shown in the Example
below always displays a value of zero.
Example
FTOS#show sflow
sFlow services are enabled
Global default sampling rate: 32768
Global default counter polling interval: 20
1 collectors configured
Collector IP addr: 133.33.33.53, Agent IP addr: 133.33.33.116,
UDP port: 6343
0 UDP packets exported
0 UDP packets dropped
165 sFlow samples collected
0 sFlow samples dropped due to sub-sampling
Linecard 1 Port set 0 H/W sampling rate 8192
Gi 1/16: configured rate 8192, actual rate 8192, sub-
sampling rate 1
Gi 1/17: configured rate 16384, actual rate 16384, sub-
sampling rate 2
Linecard 3 Port set 1 H/W sampling rate 16384
Gi 3/40: configured rate 16384, actual rate 16384, sub-
sampling rate 1
FTOS#
show sflow linecard
Display the sFlow information on a line card.
C-Series, E-Series, S-Series, Z-Series
Syntax
show sflow linecard {slot number}
Parameters
slot number (OPTIONAL) Enter a slot number to view information on the line card
in that slot. The range is 0 to 13 on a E1200, 0 to 6 on a E600/E600i, and
0 to 5 on a E300.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on S-Series Stacking.
1359