Version 6.3.1.0 Introduced.
Related
Commands
• distribute-list out – suppresses networks from being advertised in updates.
• redistribute – redistributes routes from one routing domain to another routing domain.
distribute-list out
Suppress network prefixes from being advertised in outbound updates.
E-Series, S4810
Syntax
distribute-list prefix-list-name out [connected | bgp as number
| ospf process-id | rip | static]
To return to the default values, use the no distribute-list prefix-list-name
out [bgp as number connected | ospf process-id | rip | static]
command.
Parameters
prefix-list-name
Specify the prefix list to filter prefixes in routing updates.
connected (OPTIONAL) Enter the keyword connected for directly connected
routing process.
ospf
process-id
(OPTIONAL) Enter the keyword ospf followed by the OSPF process-
ID number. The range is 1 to 65535.
bgp
as number
(OPTIONAL) Enter the BGP followed by the AS Number. The range is 1
to 65535.
rip (OPTIONAL) Enter the keyword rip for RIP routes.
static (OPTIONAL) Enter the keyword static for user-configured routing
process.
Defaults Not configured.
Command Modes
• ROUTER ISIS (
for IPv4
)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (
for IPv6
)
Command History
Version 8.3.12.0 Introduced on the S4810.
Version 7.5.1.0 Added IPv6 ISIS support.
Version 6.3.1.0 Introduced.
Usage
Information
You can assign a name to a routing process so a prefix list IS applied to only the routes derived
from the specified routing process.
866
To Next Page
Loading...
