Dell Force10 Z9000 - Show Isis Protocol; Show Isis Traffic

Adjacency being used for MTs: IPv4 IPv6
FTOS#
show isis protocol
Display IS-IS routing information.
E-Series, S4810
Syntax
show isis protocol
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.12.0 Introduced on the S4810.
Example
The bold section below identifies that Multi-Topology IS-IS is enabled.
FTOS#show isis protocol
IS-IS Router: <Null Tag>
System Id: F100.E120.0013 IS-Type: level-1-2
Manual area address(es):
49.0000.0001
Routing for area address(es):
49.0000.0001
Interfaces supported by IS-IS:
GigabitEthernet 1/0 - IP - IPv6
GigabitEthernet 1/1 - IP - IPv6
GigabitEthernet 1/10 - IP - IPv6
Loopback 0 - IP - IPv6
Redistributing:
Distance: 115
Generate narrow metrics: level-1-2
Accept narrow metrics: level-1-2
Generate wide metrics: none
Accept wide metrics: none
Multi Topology Routing is enabled in transition mode.
FTOS#
show isis traffic
This command allows you to display IS-IS traffic interface information.
E-Series, S4810
Syntax
show isis traffic [interface]
902