Dell Force10 Z9000 - Redistribute

pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
Although the passive interface is neither send nor receive routing updates, the network on that
interface still includes in RIP updates sent using other interfaces.
Related
Commands
neighbor – enables RIP for a specified network.
network – defines a neighbor.
redistribute
Redistribute information from other routing instances.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
redistribute {connected | static}
To disable redistribution, use the no redistribute {connected | static} command.
Parameters
connected Enter the keyword connected to specify that information from
active routes on interfaces is redistributed.
static Enter the keyword static to specify that information from static
routes is redistributed.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
To redistribute the default route (0.0.0.0/0), configure the default-information
originate
command.
Related
Commands
default-information originate – generates a default route for RIP traffic.
1250