Dell Force10 Z9000 - Show Ip Igmp Snooping Mrouter

Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
This command enables the IGMP switch to send General Queries periodically. This is useful
when there is no multicast router present in the VLAN because the multicast traffic does not
need to be routed. You must assign an IP address to the VLAN interface for the switch to act as
a querier for this VLAN.
show ip igmp snooping mrouter
Display multicast router interfaces.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip igmp snooping mrouter [vlan number]
Parameters
vlan number Enter the keyword vlan followed by the vlan number. The range is 1
to 4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command.
Usage
Information
If the port channel is a VLT port channel, an asterisk (*) after the port channel number (Po 100*)
indicates the port channel is locally down and that a remote VLT port is up.
Example
FTOS#show ip igmp snooping mrouter
Interface Router Ports
Vlan 2 Gi 13/3, Po 1
FTOS#
685