Dell Force10 Z9000 - Delay-Restore; Lacp Ungroup Member-Independent

delay-restore
Configure the delay in bringing up VLT ports after reload or peer-link restoration between the VLT peer switches.
Z-Series, S4810
Syntax
delay-restore
Parameters
delay-restore Enter the amount of time, in seconds, to delay bringing up the VLT
ports after the VLTi device is reloaded or after the peer-link is
restored between VLT peer switches. The range 1 to 1200. The default
is 90 seconds.
Defaults Not configured.
Command Modes VLT DOMAIN
Command History
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.12.0 Introduced on the S4810.
Usage
Information
Use the delay-restore parameter to delay the system from bringing up the VLT port for a
brief period to allow IGMP Snooping and Layer 3 routing protocols to converge. Use this
feature:
• after a VLT device is reloaded.
• if the Peer VLT device was up at the time the VLTi link failed to the time when it was
restored.
Related
Commands
show vlt statistics – displays statistics on VLT operations.
lacp ungroup member-independent
Prevent possible loop during the bootup of a VLT peer switch or a device that accesses the VLT domain.
Z-Series, S4810
Syntax
lacp ungroup member-independent {vlt | port-channel}
Parameters
port-channel Force all LACP port-channel members to become switchports.
vlt Force all VLT LACP members to become switchports.
Example
FTOS (conf)#lacp ungroup member-independent ?
port-channel LACP port-channel members become
switchports
1459