Dell Force10 Z9000 - Debug Ip Bgp Events

To disable debugging, use the no debug ip bgp ipv6 unicast dampening
command.
Parameters
in (OPTIONAL) Enter the keyword in to view only information on
inbound dampened routes.
out (OPTIONAL) Enter the keyword out to view only information on
outbound dampened routes.
Command Modes EXEC Privilege
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
Usage
Information
Enter the no debug ip bgp command to remove all configured debug commands for BGP.
Related
Commands
show ip bgp dampened-paths – View BGP dampened routes.
debug ip bgp events
Allows you to view information on local BGP state changes and other BGP events.
C-Series, E-Series
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name] events
[in | out]
To disable debugging, use the no debug ip bgp ipv6-address | peer-group
peer-group-name] events command.
Parameters
ipv6-address (OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format followed by
the prefix length in the /x format. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group peer-
group-name
(OPTIONAL) Enter the keywords peer-group followed by the name
of the peer group.
in (OPTIONAL) Enter the keyword in to view only information on
inbound BGP routes.
out (OPTIONAL) Enter the keyword out to view only information on
outbound BGP routes.
Command Modes EXEC Privilege
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
473