Dell Force10 Z9000 - Per-Port Qos Commands; Dot1 P-Priority

Per-Port QoS Commands
Per-port QoS (port-based QoS) allows you to define the QoS configuration on a per-physical-port basis.
dot1p-priority
Assign a value to the IEEE 802.1p bits on the traffic received by this interface.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
dot1p-priority priority-value
To delete the IEEE 802.1p configuration on the interface, use the no dot1p-priority
command.
Parameters
priority-value Enter a value from 0 to 7.
dot1p Queue Number
0 2
1 0
2 1
3 3
4 4
5 5
6 6
7 7
For the C-Series and S-Series, enter a value 0, 2, 4, or 6.
dot1p Queue Number
0 1
1 0
2 0
3 1
4 2
5 2
6 3
7 3
Defaults
none
1182