Dell Force10 Z9000 - Snmp-Server Community

alias | more
IF-MIB::ifAlias.134530304 = STRING: This is a port connected
to Router2. This is a
port connected to
IF-MIB::ifAlias.134792448 = STRING:
!----command run on Force10 switch:-----------!
FTOS#snmp ifmib ifalias long
!----command run on server connected to switch:------!
> snmpwalk -c public 10.10.10.130 .1.3.6.1.2.1.31 | grep -i
alias | more
IF-MIB::ifAlias.134530304 = STRING: This is a port connected
to Router2. This is a
port connected to Router2. This is a port connected to
Router2. This is a port
connected to Router2. This is a port connected to Router2.
IF-MIB::ifAlias.134792448 = STRING:
snmp-server community
Configure a new community string access for SNMPv1 v2 and v3.
C-Series, E-Series, S-Series, Z-Series
Syntax
snmp-server community community-name {ro | rw} [ipv6 ipv6-
access-list-name [ipv6 ipv6-access-list-name | access-list-name
| security-name name] | security-name name [ipv6 ipv6-access-
list-name | access-list-name | security-name name] | access-
list-name [ipv6 ipv6-access-list-name | access-list-name |
security-name name]]]
To remove access to a community, use the no snmp-server community
community-string {ro | rw} [security-name name [access-list-
name
| ipv6 access-list-name | access-list-name ipv6 access-
list-name]] command.
Parameters
community-name Enter a text string (up to 20 characters long) to act as a password for
SNMP.
ro Enter the keyword ro to specify read-only permission.
rw Enter the keyword rw to specify read-write permission.
ipv6 access-list-
name
(Optional) Enter the keyword ipv6 followed by a an IPv6 ACL name
(a string up to 16 characters long).
security-name
name
(Optional) Enter the keywords security-name followed by the
security name as defined by the community MIB.
access-list-name (Optional) Enter a standard IPv4 access list name (a string up to 16
characters long).
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
1365