Dell Force10 Z9000 - Online Stack-Unit; Buffer Tuning Commands

Warning - Diagnostic execution will cause stack-unit to reboot
after completion of diags.
Proceed with Offline-Diags [confirm yes/no]:y
Related
Commands
show environment (S-Series) – views the S-Series system component status (for example,
temperature, voltage).
online stack-unit
Place a stack unit in the online state.
S-Series, Z-Series
Syntax
online stack-unit number
Parameters
number Enter the stack-unit number.
• S4810 range is 0 to 11.
• Z9000 range is 0 to 7.
Defaults none
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 7.7.1.0 Introduced on the S-Series.
Usage
Information
You cannot enter this command on a Master or Standby unit.
The system reboots when the off-line diagnostics complete. This is an automatic process. A
warning message appears when the offline stack-unit command is implemented.
Warning - Diagnostic execution will cause stack-unit to reboot
after completion of diags.
Proceed with Offline-Diags [confirm yes/no]:y
Related
Commands
show environment (S-Series) – views the S-Series system component status (for example,
temperature, voltage).
Buffer Tuning Commands
The following sections detail the buffer tuning commands.
WARNING: Altering the buffer allocations is a sensitive operation. Do not use any buffer tuning commands without
first contacting the Dell Force10 Technical Assistance Center (TAC).
573