Dell Force10 Z9000 - Rmon Hc-Alarm

owner name (OPTIONAL) Enter the keyword owner followed by the name of the
owner of this event.
Defaults As noted above.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.1.1.0 Introduced on the E-Series.
rmon hc-alarm
Set an alarm on any MIB object.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
rmon hc-alarm number variable interval {delta | absolute}
rising-threshold value event-number falling-threshold value
event-number [owner string]
To disable the alarm, use the no rmon hc-alarm number command.
Parameters
number Enter the alarm integer number from 1 to 65535. The value must be
unique in the RMON alarm table.
variable The MIB object to monitor. The variable must be in the SNMP OID
format; for example, 1.3.6.1.2.1.1.3 The object type must be a 64 bit
integer.
interval Time, in seconds, the alarm monitors the MIB variables; this is the
alarmSampleType in the RMON alarm table. The range is 5 to 3600
seconds.
delta Enter the keyword delta to test the change between MIB variables.
This is the alarmSampleType in the RMON alarm table.
absolute Enter the keyword absolute to test each MIB variable directly.
This is the alarmSampleType in the RMON alarm table.
rising-threshold
value event-
number
Enter the keywords rising-threshold followed by the value (64
bit) the rising-threshold alarm is either triggered or reset. Then enter
the event-number to trigger when the rising threshold exceeds its
limit. This value is the same as the alarmRisingEventIndex or
alarmTable of the RMON MIB. If there is no corresponding rising-
threshold event, the value is zero.
1263