shutdown
FTOS(conf-if-0/52)#exit
FTOS(config)#
Related
Commands
show config – displays the configuration of the selected interface.
dampening
Configure dampening on an interface.
C-Series, E-Series, S-Series, Z-Series
Syntax
dampening [[[[half-life] [reuse-threshold]] [suppress-
threshold]] [max-suppress-time]]
Parameters
half-life
Enter the number of seconds after which the penalty is decreased.
The penalty is decreased by half after the half-life period expires. The
range is 1 to 30 seconds. The default is 5 seconds.
reuse-threshold
Enter a number as the reuse threshold, the penalty value below which
the interface state is changed to “up”. The range is 1 to 20000. The
default is 750.
suppress-
threshold
Enter a number as the suppress threshold, the penalty value above
which the interface state is changed to “error disabled”. The range is
1 to 20000. The default is 2500.
max-suppress-
time
Enter the maximum number for which a route can be suppressed. The
default is four times the half-life value. The range is 1 to 86400. The
default is 20 seconds.
Defaults Disabled.
Command Modes INTERFACE (conf-if-)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
With each flap, FTOS penalizes the interface by assigning a penalty (1024) that decays
exponentially depending on the configured half-life. After the accumulated penalty exceeds the
suppress threshold value, the interface moves to the Error-Disabled state. This interface state
is deemed as “down” by all static/dynamic Layer 2 and Layer 3 protocols. The penalty is
exponentially decayed based on the half-life timer. After the penalty decays below the reuse
threshold, the interface enables. The configured parameters are as follows:
691
To Next Page
Loading...
