Dell Force10 Z9000 - Ipv6 Ospf Priority; Ipv6 Router Ospf

Related
Commands
ipv6 ospf dead-
interval
Specify the time interval between hello packets was received from a
router.
ipv6 ospf priority
Set the priority of the interface to determine the Designated Router for the OSPFv3 network.
C-Series, E-Series, Z-Series, S4810
Syntax
ipv6 ospf priority number
To return to the default time interval, enter no ipv6 ospf priority.
Parameters
number
Enter the number as the priority.
Range: 1 to 255.
Defaults 1
Command Modes INTERFACE
Command History
Version 9.1.(0.0) Introduced on the S4810 and Z9000.
Version 7.8.1.0 Added support for the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
Setting a priority of 0 makes the router ineligible for election as a Designated Router or Backup
Designated Router.
Use this command for interfaces connected to multi-access networks, not point-to-point
networks.
ipv6 router ospf
Enable OSPF for IPv6 router configuration.
C-Series, E-Series, Z-Series, S4810
Syntax
ipv6 router ospf process-id
To exit OSPF for IPv6, enter no ipv6 router ospf process-id .
Parameters
process-id
Enter the process identification number.
Range: 1 to 65535.
Defaults No default behavior or values.
Command Modes CONFIGURATION
Command History
Version 9.1.(0.0) Introduced on the S4810 and Z9000.
1117