Dell Force10 Z9000 - Rpm <Slot> Location-Led

NOTE: This option is supported on the C-Series only.
rpm number Enter the keyword rpm followed by a number for the RPM slot
number. Range: 0 to 1.
(Optional) Add the keyword hard or power-cycle (C-Series only)
to power cycle the RPM.
sfm slot number Enter the keyword sfm followed by the failed or powered-off SFM
slot number.
NOTE: Supported on the E-Series only.
Defaults Disabled.
Command Modes EXEC Privilege
Command History
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage
Information
The command reset without any options is a soft reset, which means FTOS boots the line
card from its runtime image. The hard option reloads the FTOS image on the line card. Use the
power-cycle command after upgrading an FPGA.
When a soft reset is issued on a line card (reset linecard number), FTOS boots the
line card from its runtime image. Only when you enter
reset linecard number hard
is the software image reloaded on the line card.
Related
Commands
reload – reboots the system.
restore fpga-image – copies the backup C-Series FPGA image to the primary FPGA image.
rpm <slot> location-led
Toggle the location light emitting diode (LED) on/off on the E-Series ExaScale RPM (LC-EH-RPM).
E-Series ExaScale Only
Syntax
rpm slot number location-led [on | off]
Parameters
rpm slot number Enter the slot number. For the E1200i, the range is 0-13. For the E600i,
the range is 0-6.
on |off Toggles the LED on the RPM on or off.
Defaults OFF
Command Modes EXEC
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
132