Dell Force10 Z9000 - Show Cam-Acl

• Enter the keywords acl-group to select the microcode for
applications that need 16k egress IPv4 ACLs.
• Enter the keywords ipv4-vrf to select the microcode for
IPv4 VRF applications.
• Enter the keywords ipv4-v6-vrf to select the microcode
for IPv4 and IPv6 VRF applications.
• E-Series TeraScale only: Select l2-switched-pbr
microcode if you apply a PBR redirect list to a VLAN interface
and want to prevent Layer 2 traffic from being redirected and
dropped. l2-switched-pbr (IPv4-LDA) microcode allows
only Layer 3 traffic to be redirected while Layer 2 traffic is
switched within the VLAN.
Defaults cam-profile default microcode default
Command Modes CONFIGURATION
Command History
Version 8.2.1.0 Added support for the ipv4-64k-ipv6 profile.
Version 7.9.1.0 Added support for the VRF protocols.
Version 7.5.1.0 Added the l2-ipv4-inacl CAM profile.
Version 7.4.2.0 Added the unified-default CAM profile and lag-hash-
align microcode.
Version 7.4.1.0 Added the lag-hash-mpls microcode.
Version 6.5.1.0 Added the eg-default and ipv4-320k CAM profiles.
Version 6.3.1.0 Introduced on the E-Series.
Usage
Information
You must save the running configuration using the copy running-config startup-
config
command after changing the CAM profile from CONFIGURATION mode. CAM profile
changes take effect after the next chassis reboot.
NOTE: Do not use the ipv4-egacl-16 CAM profile for Layer 2 egress ACLs.
NOTE: Do not make any changes to the CAM profile after you change the profile to
ipv4-320K and save the configuration until after you reload the chassis; any changes
lead to unexpected behavior. After you reload the chassis, you may make changes to the
IPv4 Flow partition.
show cam-acl
Display the details of the CAM profiles on the chassis and all line cards.
C-Series, Z-SEries, S4810
Syntax
show cam-acl
Defaults none
Command Modes EXEC Privilege
551