Dell Force10 Z9000 - Auto-Cost

Defaults Disabled.
Command Modes ROUTER OSPF
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for the Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
Use this command to configure all routers and access servers within a stub.
Related
Commands
router ospf – enters ROUTER OSPF mode to configure an OSPF instance.
auto-cost
Specify how the OSPF interface cost is calculated based on the reference bandwidth method.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
auto-cost [reference-bandwidth ref-bw]
To return to the default bandwidth or to assign cost based on the interface type, use the no
auto-cost [reference-bandwidth]
command.
Parameters
ref-bw (OPTIONAL) Specify a reference bandwidth in megabits per second.
The range is 1 to 4294967. The default is 100 megabits per second.
Defaults 100 megabits per second.
Command Modes ROUTER OSPF
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for the Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
1040