Dell Force10 Z9000 - Snmp-Server Contact; Snmp-Server Enable Traps

snmp-server contact
Configure contact information for troubleshooting this SNMP node.
C-Series, E-Series, S-Series, Z-Series
Syntax
snmp-server contact text
To delete the SNMP server contact information, use the no snmp-server contact
command.
Parameters
text Enter an alphanumeric text string, up to 55 characters long.
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
snmp-server enable traps
Enable SNMP traps.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
snmp-server enable traps [notification-type] [notification-
option]
To disable traps, use the no snmp-server enable traps [notification-
type
] [notification-option] command.
Parameters
notification-type Enter the type of notification from the list below:
• bgp—Notification of changes in the BGP process.
• config—Notification of changes to the startup or running
configuration.
• ecfm—Notification of changes to ECFM.
• ecmp—Enable an ECMP trap to notify of ECMP or link
bumdle traffic imbalances.
• envmon—For Dell Force10 device notifications when an
environmental threshold is exceeded.
• isis—Notification of intermediate service traps.
• lacp—Notification of changes.
1367