Dell Force10 Z9000 - Neighbor Advertisement-Start; Neighbor Allowas-In

neighbor advertisement-start
Set the minimum interval before starting to send BGP routing updates.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
neighbor {ip-address} advertisement-start seconds
To return to the default value, use the no neighbor {ip-address}
advertisement-start
command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
seconds Enter a number as the time interval, in seconds, before BGP route
updates are sent. The range is 0 to 3600 seconds.
Defaults none
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
neighbor allowas-in
Set the number of times an AS number can occur in the AS path.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
neighbor {ip-address | peer-group-name} allowas-in number
To return to the default value, use the no neighbor {ip-address | peer-group-
name} allowas-in command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal
format.
peer-group-name Enter the name of the peer group to set the advertisement interval for
all routers in the peer group.
number Enter a number of times to allow this neighbor ID to use the AS path.
The range is 1 to 10.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
361