Dell Force10 Z9000 - Show Running-Config Bgp

Field Description
State/Pfxrcd
If the neighbor is in Established stage, the number of network
prefixes received.
If a maximum limit was configured with the neighbor maximum-
prefix command, (prfxd) appears in this column.
If the neighbor is not in Established stage, the current stage is
displayed (Idle, Connect, Active, OpenSent, OpenConfirm). When the
peer is transitioning between states and clearing the routes
received, the phrase (Purging) may appear in this column.
If the neighbor is disabled, the phrase (Admin shut) appears in this
column.
Example (S4810)
FTOS#show ip bgp summary
BGP router identifier 120.10.10.1, local AS number 100
BGP table version is 34, main routing table version 34
9 network entrie(s) using 1372 bytes of memory
5 paths using 380 bytes of memory
4 denied paths using 164 bytes of memory
BGP-RIB over all using 385 bytes of memory
2 BGP path attribute entrie(s) using 168 bytes of memory
1 BGP AS-PATH entrie(s) using 39 bytes of memory
1 BGP community entrie(s) using 43 bytes of memory
2 neighbor(s) using 7232 bytes of memory
Neighbor AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/
Pfx
100.10.10.2 200 46 41 34 0 0 00:14:33 5
120.10.10.2 300 40 47 34 0 0 00:37:10 0
FTOS#
show running-config bgp
Use this feature to display the current BGP configuration.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show running-config bgp
Defaults none
Command Modes EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Version 7.6.1.0 Introduced on the E-Series.
416