Dell Force10 Z9000 - Show Protocol-Termination-Table

show protocol-termination-table
Display the IP packet termination table (IPPTT).
E-Series
Syntax
show protocol-termination-table linecard number port-set port-
pipe-number
Parameters
linecard number Enter the keyword linecard followed by slot number of the line
card. For the E-Series, the range is 0 to 13 on a E1200/1200i, 0 to 6 on a
E600/E600i, and 0 to 5 on a E300.
port-set port-
pipe-number
Enter the keywords port-set followed by the line card’s Port-Pipe
number. The range is 0 to 1.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.1.1.2 Introduced on the E-Series ExaScale E600i.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 6.4.1.0 Introduced
Usage
Information
The IPPTT table is used for looking up forwarding information for IP control traffic destined to
the router. For the listed control traffic types, IPPTT contains the information for the following:
• Which CPU to send the traffic (CP, RP1, or RP2)
• What QoS parameters to set
Example
FTOS#show protocol-termination-table linecard 2 port-set 0
Index Protocol Src-Port Dst-Port Queue DP Blk-Hole VlanCPU
EgPort
--------------------------------- -- -------- --------------
0 ICMP any any Q0 0 No - CP
1 UDP any 1812 Q7 6 No - CP
2 UDP any 68 Q7 6 No - CP
3 UDP any 67 Q7 6 No - CP
4 TCP any 22 Q7 6 No - CP
5 TCP 22 any Q7 6 No - CP
6 TCP 639 any Q7 6 No - RP2
7 TCP any 639 Q7 6 No - RP2
8 TCP 646 any Q7 6 No - RP1
9 TCP any 646 Q7 6 No - RP1
10 UDP 646 any Q7 6 No - RP1
11 UDP any 646 Q7 6 No - RP1
12 TCP 23 any Q7 6 No - CP
13 TCP any 23 Q7 6 No - CP
14 UDP any 123 Q7 6 No - CP
15 TCP any 21 Q7 6 No - CP
16 TCP any 20 Q7 6 No - CP
830