Dell Force10 Z9000 - Clear Ipv6 Mld_Host; Ipv6 Address Autoconfig

Parameters
* Enter the * to clear (refresh) all routes from the IPv6 routing table.
ipv6-address
prefix-length
Enter the IPv6 address in the x:x:x:x::x format followed by the prefix
length in the /x format. The range is /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
Command Modes EXEC Privilege
Command History
Version 9.0.0.0 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series TeraScale.
clear ipv6 mld_host
Clear the IPv6 MLD host counters and reset the elapsed time.
S4810
Syntax
clear ipv6 mld_host
Command Modes EXEC
Command History
Version 8.3.12.0 Introduced on the S4810.
ipv6 address autoconfig
Configure IPv6 address auto-configuration for the management interface.
S4810
Syntax
ipv6 address autoconfig
To disable the address autoconfig operation on the management interface, use the no ipv6
address autoconfig command.
Default Disabled
Command Modes INTERFACE (management interface only)
836