Dell Force10 Z9000 - Msti

parameter to the configured value of max-hops. When a switch receives the BPDU, it
decrements the received value of the remaining hops and uses the resulting value as
remaining-hops in the BPDUs. If the remaining-hops reaches zero, the switch discards the
BPDU and ages out any information that it holds for the port.
msti
Configure multiple spanning tree instance, bridge priority, and one or multiple VLANs mapped to the MST instance.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
msti instance {vlan range | bridge-priority priority}
To disable mapping or bridge priority, use the no msti instance {vlan range |
bridge-priority
priority} command.
Parameters
msti instance Enter the MSTP iInstance. The range is zero (0) to 63.
vlan range Enter the keyword vlan followed by the identifier range value. The
range is 1 to 4094.
bridge-priority
priority
Enter the keywords bridge-priority followed by a value in
increments of 4096 as the bridge priority. The range is zero (0) to
61440.
Valid priority values are: 0, 4096, 8192, 12288, 16384, 20480, 24576,
28672, 32768, 36864, 40960, 45056, 49152, 53248, 57344, and 61440. All
other values are rejected.
Defaults default bridge-priority is 32768.
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 6.5.1.0 Introduced.
Usage
Information
By default, all VLANs are mapped to MST instance zero (0) unless you use the vlan range
command to map it to a non-zero instance.
996