Dell Force10 Z9000 - Set Metric; Set Metric-Type

Usage
Information
The set local-preference command changes the LOCAL_PREF attribute for routes
meeting the route map criteria. To change the LOCAL_PREF for all routes, use the bgp
default local-preference
command.
Related
Commands
bgp default local-preference – changes the default LOCAL_PREF attribute for all routes.
set metric
Configure a filter to assign a new metric to redistributed routes.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
set metric [+ | -] metric-value
To delete a setting, enter no set metric.
Parameters
+ (OPTIONAL) Enter + to add a metric-value to the redistributed routes.
- (OPTIONAL) Enter - to subtract a metric-value from the redistributed
routes.
metric-value Enter a number as the new metric value. The range is zero (0) to
4294967295.
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
set automatic-tag – computes the tag value of the route.
set level – specifies the OSPF area for route redistribution.
set metric-type – specifies the route type assigned to redistributed routes.
set tag – specifies the tag assigned to redistributed routes.
set metric-type
Configure a filter to assign a new route type for routes redistributed to OSPF.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
set metric-type {internal | external | type-1 | type-2}
298