Dell Force10 Z9000 - Mac Learning-Limit Station-Move-Violation; Mac Learning-Limit Reset

mac learning-limit station-move-violation
Specify the actions for a station move violation.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
mac learning-limit station-move-violation {log | shutdown-both
| shutdown-offending | shutdown-original}
To disable a configuration, use the no mac learning-limit station-move-
violation command, followed by the configured keyword.
Parameters
log Enter the keyword log to generate a syslog message on a station
move violation.
shutdown-both Enter the keyword shutdown to shut down both the original and
offending interface and generate a syslog message.
shutdown-
offending
Enter the keywords shutdown-offending to shut down the
offending interface and generate a syslog message.
shutdown-
original
Enter the keywords shutdown-original to shut down the
original interface and generate a syslog message.
Defaults none
Command Modes INTERFACE (conf-if-interface-slot/port)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the S-Series.
Version 7.8.1.0 Introduced on the C-Series.
Version 7.5.1.0 Introduced on the E-Series.
Usage
Information
This is supported on physical interfaces, static LAGs, and LACP LAGs.
Related
Commands
show mac learning-limit – displays details of the mac learning-limit.
mac learning-limit reset
Reset the MAC address learning-limit error-disabled state.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
mac learning-limit reset
925