Dell Force10 Z9000 - Show Ip Pim Neighbor

172.21.110.1 Gi 13/6 v2/S 0 30 1 172.21.110.1
172.21.203.1 Gi 13/7 v2/S 0 30 1 172.21.203.1
show ip pim neighbor
View PIM neighbors.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show ip pim neighbor
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.12.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Introduced on the S-Series.
Usage
Information
The following describes the show ip pim neighbor command shown in the Example
below.
Field Description
Neighbor address Displays the IP address of the PIM neighbor.
Interface List the interface type, with either slot/port information or ID (VLAN
or Port Channel), on which the PIM neighbor was found.
Uptime/expires Displays the amount of time the neighbor has been up followed by
the amount of time until the neighbor is removed from the multicast
routing table (that is, until the neighbor hold time expires).
Ver Displays the PIM version number.
• v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode.
• 1 = default Designated Router priority (use the ip pim
dr-priority command)
• DR = Designated Router
• S = Sparse mode
Example
FTOS#show ip pim neighbor
Neighbor Interface Uptime/Expires Ver DR
Address Prio/Mode
1141