Dell Force10 Z9000 - Show Config

Usage
Information
The remark command is available in each ACL mode. You can configure up to 4294967290
remarks in a given ACL.
The example below shows the use of the remark command twice within CONFIGURATION-
STANDARD-ACCESS-LIST mode. The same sequence number was used for the remark and for
an associated ACL rule. The remark precedes the rule in the running-config because it is
assumed that the remark is for the rule with the same sequence number, or the group of rules
that follow the remark.
Example
FTOS(config-std-nacl)#remark 10 Deny rest of the traffic
FTOS(config-std-nacl)#remark 5 Permit traffic from XYZ Inc.
FTOS(config-std-nacl)#show config
!
ip access-list standard test
remark 5 Permit traffic from XYZ Inc.
seq 5 permit 1.1.1.0/24
remark 10 Deny rest of the traffic
seq 10 Deny any
FTOS(config-std-nacl)#
Related
Commands
show config – displays the current ACL configuration.
show config
Display the current ACL configuration.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
show config
Command Modes
• CONFIGURATION-STANDARD-ACCESS-LIST
• CONFIGURATION-EXTENDED-ACCESS-LIST
• CONFIGURATION-MAC ACCESS LIST-STANDARD
• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1
Introduced on the E-Series.
Example
FTOS(config-ext-nacl)#show conf
!
ip access-list extended patches
FTOS(config-ext-nacl)#
213