Dell Force10 Z9000 - Member-Vlan; Mode

member-vlan
Specify the member VLAN identification numbers.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
member-vlan {vlan-range}
To return to the default, use the no member-vlan [vlan-range] command.
Parameters
vlan-range Enter the member VLANs using VLAN IDs (separated by commas), a
range of VLAN IDs (separated by a hyphen), a single VLAN ID, or a
combination. For example: VLAN IDs (comma-separated): 3, 4, 6.
Range (hyphen-separated): 5-10. Combination: 3, 4, 5-10, 8.
Defaults none
Command Modes CONFIGURATION (conf-frrp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced.
mode
Set the Master or Transit mode of the ring.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax
mode {master | transit}
To reset the mode, use the no mode {master | transit} command.
Parameters
master Enter the keyword master to set the Ring node to Master mode.
transit Enter the keywordtransit to set the Ring node to Transit mode.
Defaults Mode None
Command Modes CONFIGURATION (conf-frrp)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series.
644