bgp (OPTIONAL) Enter the keyword bgp to specify that BGP routes are
distributed.
NOTE: BGP and ISIS routes are not available on the C-Series.
BGP, ISIS, and RIP routes are not available on the S-Series.
connected (OPTIONAL) Enter the keyword connected to specify that
connected routes are distributed.
isis (OPTIONAL) Enter the keyword isis to specify that IS-IS routes are
distributed.
NOTE: BGP and ISIS routes are not available on the C-Series.
BGP, ISIS, and RIP routes are not available on the S-Series.
rip (OPTIONAL) Enter the keyword rip to specify that RIP routes are
distributed.
NOTE: BGP and ISIS routes are not available on the C-Series.
BGP, ISIS, and RIP routes are not available on the S-Series.
static (OPTIONAL) Enter the keyword static to specify that only manually
configured routes are distributed.
Defaults Not configured.
Command Modes ROUTER OSPF
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for the Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Usage
Information
The distribute-list out command applies to routes being redistributed by
autonomous system boundary routers (ASBRs) into OSPF. It can be applied to external type 2
and external type 1 routes, but not to intra-area and inter-area routes.
enable inverse mask
By default, FTOS allows you to input the OSPF network command with a net-mask. This command provides a choice
between inverse-mask or net-mask (the default).
C-Series, E-Series, Z-Series
Syntax
enable inverse mask
To return to the default net-mask, use the no enable inverse mask command.
Defaults net-mask
1050
To Next Page
Loading...
